|
Front Brake Caliper Bleed Nipple 3/8 UNF in bright zinc plate.
...
|
|
|
|
Price: £2.54
|
 |
|
|
|
Especially made Stainless Steel Insert to prevent over tightening of Brake Fluid Reservoir to Master Cylinder body.
These hold the Reservoir at the ...
|
|
|
|
Price: £4.55
|
|
|
|
|
Insert to prevent over tightening of Brake Fluid Reservoir to Master Cylinder body.
These hold the Reservoir at the correct height above the cylinde...
|
|
|
|
Price: £0.99
|
|
|
|
|
Brake Master Cylinder Reservoir only
DOES NOT INCLUDE CAP
Caps can usually be cleaned up nicely.
Carries original AP Lockheed Markings ...
|
|
|
Price: £16.50
|
|
|
|
![Brake Pads ASBESTOS FREE [ GBP242 ] GBP1179AF](shopthumbs/10.jpg)
|
Four Original Equipment Quality Brake Pads by Borg Beck.
Replaces GBP242AF or the former GBP242 which contains asbestos - the letters AF equate to ...
|
|
|
Price: £15.71
|
|
|
|
![Brake Pipe Clip 3/16 [aka GHF1192,GFK 7511] 623312](shopthumbs/214.jpg)
|
Push fit `one shot` Brake Pipe Clip in black to hold 3/16 pipe. The locations are
The front cross member.
The rear trailing arm casting
The BL P...
|
|
|
Price: £0.33
|
|
|
|
|
Zinc Plated `BZP` 3/8 UNF Male Tube or Brake Pipe tube nut used at Master Cylinder, PDWA Switch and other joints requiring a male connector. ...
|
|
|
|
From: £0.28
|
|
|
|
|
Air Clip in plastic to support Brake Pipes.
The illustration in the BL Triumph Stag Catalogue on page 4.62 is incorrect.
This is clip 625521 as sh...
|
|
|
|
Price: £0.92
|
|
|
|
|
PLEASE NOTE POSTAGE IS HIGH BECAUSE ONLY ROYAL MAIL MAIL WILL CARRY THIS ITEM
1/2 litre bottle of TRW brand Brake fluid DOT 5.1.
DOT 5.1 has a wet boiling point of 375 degrees.
Better yet, DOT 5.1 is half as viscous as DOT 4...
|
|
|
Price: £6.75
|
|
|
|
![Copper Crush Washer 3/8 [ 233220 ] 107072](shopthumbs/658.jpg)
|
Copper Crush Washer for use in assembling brake lines.
The BL information shows 107072 officially supersedes to 233220.
Genuine Land Rover Part pro...
|
|
|
Price: £0.65
|
|
|
|
![Flat Washer Stainless [aka 501196] WP7SS 1/4 x 9/16](shopthumbs/369.jpg)
|
Stainless Steel Washer 1/4 internal diameter where Stainless can be helpful.
Consider using with Brake Master Cylinder Reservoir Screws or in place...
|
|
|
|
Price: £0.16
|
|
|
|
|
This screws into the brass body of PDWA housing and the exposed pin engages with the valley in the shuttle.
Should pressure be lost in the forward ...
|
|
|
|
Price: £28.82
|
|
|
|
