|
E clip for retaining the Wiper Motor Gear Wheel on its axle pin...
|
|
|
|
Price: £0.37
|
 |
|
|
|
Grommet 3/4ins x 1/8ins for 1/2ins diameter hole to carry the Windscreen Washer Tubing or Bonnet Release Cable through the bulkhead or firewall.
...
|
|
|
|
Price: £1.66
|
|
|
|
|
Black Plastic Remote or Bracket mounted washer pump. 12V
Alternative to WEP01 as seen in lower photograph.
Lighter than WEP01
Held together wit...
|
|
|
|
Price: £10.73
|
|
|
|
|
Tubing for inside the washer bottle. There is sufficient for both pieces supplied in this short length to be cut once as appropriate....
|
|
|
Price: £0.46
|
|
|
|
|
Washer nozzle for the centre of the Air Intake Grille.
This is not absolutely as original but it is the current one offered by the original manufactu...
|
|
|
|
Price: £8.26
|
|
|
|
|
These 14 inch refills are suitable for installation in original centre hinged Trico speedblade wiper blade frames or SOCTFL funded replicas. They are ...
|
|
|
|
Price: £11.34
|
|
|
|
|
Carbon Brush to fit Wiper Motor. Three pieces are required of which one may need a little alteration with a small knife.
The High cost is in part due...
|
|
|
Price: £12.03
|
|
|
|
|
Soft rubber pad located under Wiper motor. Photograph shows both sides.
...
|
|
|
|
Price: £4.95
|
|
|
|
